Moderator: The00Dustin
aegis wrote:care to comment on usability of the Norwegian/Danish layout?
Minox wrote:If it is built like my silver MacNTouch, then you could just change the cable. Would have to remove the tabs too...
Apparently the cable is a copper foil ribbon on Kapton tape. It has 4 traces with the same pitch as the USB standard and terminate on one end in a 20 pin 1mm pitch for the ZIF socket inside the board.
Looking at the L board and the cable that goes from the board INTO the L board you do not NEED the 20 pin milling. Just a ribbon with 4 traces at the right pitch should work everywhere.
Users browsing this forum: No registered users and 1 guest